Wednesday, May 15, 2019

Organic Chemistry Lab Essay Example | Topics and Well Written Essays - 500 words

Organic Chemistry Lab - demonstrate ExampleYou would take a sample from two of the compounds, X and Y, scuffle them. If the result of a take down break up question is present, past the two atomic number 18 different compounds. Then take X and Z, mix them. If the result of a lowered melting point is present, then the two are different compounds. Do the same with Y and Z and mix them. If the result of a lowered melting point is present, then the two are different compounds. Thus all three compounds are different, if the melting point was proven to be lowered.Question 4-One of the most common causes of inaccurate melting points is too rapid change of the melting point bath. Under these circumstances, how will the observed melting point compare to the true melting point? If the heating block is heated too rapidly, the thermometer cannot keep up, and reads a value which is lower than the actual temperature of the heating block and of the compound.Question 5-Strictly speaking, why is it incorrect to speak of a melting point? Experimentally, it is extremely problematical to establish the exact temperature at which this equilibrium is established therefore, the temperature range over which liquid and solid are found to coexist is called the melting point. For example, a solid may be reported to have a melting point of 100-101oC this means that, on heating slowly, the first droplet of liquid was observed at 100oC and the farthest crystal of solid disappeared at 101oC.Question 6-What effect would the incomplete drying of a sample (for example, the incomplete remotion of a recrystallization solvent) have on the melting point? Incomplete drying will contaminate the crystal and set down the melting point.Question 7-Why should the melting point sample be finely powdered? A fine powdered sample makes the heat transfer into the sample more efficient and reproducible, and also enhances the overall ponder ability of the sample for easier automated detection of the

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.