Electronic Laboratory Practise Lab Report Example | Topics and Well Written Essays - 500 words

Electronic Laboratory Practise - Lab Report ExampleTherefore, the have foeman is given byIn this report, knowledge and experience in the use of essential science laboratory equipment was acquired. The use of the oscilloscope, the signal generator, the power supply and digital multimeter were used to understand applications of various electronic circuits. The limited accuracy of the laboratory measuring instruments was equally demonstrated.The color coded resistors were read to establish the resistance of the resistors. After the resistance was heedful using a digital meter and it was then confirmed whether the results depict similar resistance.The resistances measured are approximately equal with slight variation that is due to manufacturers errors that cannot be avoided in the manufacturing process (Purrington, 1997). The tolerances provided typeset the appropriate limit of acceptable resistance. For the 5 ohms resistor (5 0.05) therefore 4.998 is within the range. Similarly, the lower boundary for 22 ohm resistor is (22 1.1) while the 20.9 ohms lower boundary lies within the range.The likely estimate of the potentialitys when 5 ohms and 22 ohms resistors were affiliated to 6.0 V supply to create a potential divider was determined theoretically. A digital multimeter was affiliated across each of the resistors and voltages obtained were compared. The results obtained were recorded as shown.From the results obtained, it is clear that the outsizer resistor receives the greatest share of the voltage in a voltage divider. Internal resistance of the multimeter adversely affects the measured voltage in cases where large current is drawn (Hector, Lein, & Scouten, 1943). In this case the amount of current drawn is relatively small whence there is no significant effect on the measured voltage.The current through the two resistors which were in parallel was determined theoretically and